The Periodic Verification Kit is a convenient, economical approach to performing electrostatic measurements that require a Charge Plate Monitor.   The kit includes : a case, a tripod, a 1200 Volt Dual Polarity Charger, a Periodic Test Meter (same as Hand-E-Stat Fieldmeter), and two Test Plates (1" x 2.5" and 6" x 6")

Power required :
Two 9 VDC alkaline batteries : one for the Dual Polarity Charger and one for the Periodic Test Meter.

Dual Polarity Charger :
Power : 9 VDC alkaline battery
Output : 1200 V +/- 5V
Probe length : 1.5"
Size : (W) 2.375" x (D) 1.125" x (H) 4.25
Weight : 5.5 oz (with battery)

Periodic Test Meter :
Power : 9 VDC alkaline battery
Display : 3 1/2 digit with 0.4" height, Automatic polarity change, low battery indicator "BAT"
Range : 0 to 1.999 kV (+/- 5%) (Meter reading divided by 10).
Response : Digital display updates 3 times per second.
Control : On/Off slide switch, Measure/Hold push-button, Zero Knob.
Output : Analog output at 5 Hz response, on subminiature jack providing +/-1 V corresponds to +/- 1 V.

Two Test Plates :
- Plate area : 1" x 2.5" and 6" x 6"

Environmental :
Operating Temperature : 0 - 50 deg C
Relative Humidity  : 0 - 85% (noncondensing)

Size (Total Kit including case) : (W) 12" x (D) 8" x (H) 4"
Weight (Total Kit including case) : 3.7 lb (battery included)

Specification are subjected to change without prior notice
(End of Page)